Do not trust the page. Check it.

1. 1 · Open the record page. Lock #16 on Robinhood Chain — every figure there was read with eth_call in your browser, not from a database.
2. 2 · Press “Read on chain” in “Verify this page”. The page calls vault.getLock(16) and compares the result field by field with what it rendered. If anything differs it says so; the contract wins.
3. 3 · Do the same without us. Open the vault on Blockscout, choose Read contract, call getLock(16), and compare the same fields. The Code tab also shows the runtime bytecode — the record page prints its keccak256, so you can check Sourcify's Exact Match against it.

These are raw JSON-RPC calls. The data is a 4-byte selector followed by ABI-encoded arguments. Replace the lock id (the final 64 hex digits) with the one you care about.

Vault · getLock(uint256) · selector 0xd68f4dd1 — this example reads lock #33 (0x21):

curl -s https://rpc.mainnet.chain.robinhood.com \
  -H 'content-type: application/json' \
  -d '{"jsonrpc":"2.0","id":1,"method":"eth_call","params":[{"to":"0xe410d0a21C1376992874a9bEEeE0d623A50D4a34","data":"0xd68f4dd10000000000000000000000000000000000000000000000000000000000000021"},"latest"]}'

Decode the returned words with any ABI decoder (ethers, viem, cast) or compare them with the record page. The first words are the token, start time, unlock times, steps, amount and claimed amount.

Vault · nextLockId() · selector 0x6518a0b3 — the next id, so the latest lock is one less:

curl -s https://rpc.mainnet.chain.robinhood.com \
  -H 'content-type: application/json' \
  -d '{"jsonrpc":"2.0","id":1,"method":"eth_call","params":[{"to":"0xe410d0a21C1376992874a9bEEeE0d623A50D4a34","data":"0x6518a0b3"},"latest"]}'

Bond oracle · latestRoundData() · selector 0xfeaf968c:

curl -s https://rpc.mainnet.chain.robinhood.com \
  -H 'content-type: application/json' \
  -d '{"jsonrpc":"2.0","id":1,"method":"eth_call","params":[{"to":"0x9BC910D817b96174704C340fF791E7eC53b82596","data":"0xfeaf968c"},"latest"]}'

On an explorer, use the Read contract tab instead of raw JSON-RPC — it decodes the result for you. The selectors above are the same calls.